Siberian Larch timber Slatted Fence Panels A Grade Double Sided Hit and Miss 6ft Wide

Grade A Siberian larch double-sided panel

This hit-and-miss panel uses alternating battens on both faces to create a finished appearance from either side. It is well suited to shared boundaries and garden divisions where both elevations remain visible.

Available sizes

• Standard width: 183cm (6ft)
• Available heights: 30, 60, 90, 120, 150, 180 and 210cm
• Construction: double-sided hit and miss
• Material: Grade A Siberian larch

Privacy and airflow

The alternating arrangement reduces direct sight lines while allowing air to move through the panel. The exact appearance can vary slightly because larch is a natural material.

Natural larch timber

Larch has an attractive grain and warm natural colour. Variations in colour, grain and knots are normal characteristics of timber. If left untreated, the surface will gradually weather to a silver-grey tone. A suitable exterior oil can be applied and maintained if you wish to retain more of the original colour.

Planning the installation

Check the finished opening, post spacing and required clearances before ordering. The posts, foundations, fixings and installation method must be suitable for the panel dimensions and conditions at the property. Seek advice from a competent installer if you are unsure.

Delivery and lead time

This product is made to order. Standard production is normally completed within 10–14 working days, although lead times can vary during busy periods. Please contact us before ordering if your project is time-sensitive or requires a bespoke size.

Stackable Venetian Panels — How Your Order Will Be Supplied

Effective for orders placed on or after 12 October 2026.

To make panels easier to handle and help us offer a more affordable delivery service using one driver, Venetian fence panels above 90cm high will be supplied in stackable sections.

This applies to all our larch, Scandinavian redwood, cedar and coloured Venetian fencing ranges with either 7mm or 20mm gaps.

The sections are installed one above the other to create your ordered panel height. Once correctly installed, the finished appearance is exactly the same as a single full-height panel.

Sections supplied per ordered panel

Each section retains the ordered panel width. For example, a 150cm-high × 1830mm-wide panel will arrive as one 90cm-high section and one 60cm-high section, both 1830mm wide.

Consistent gaps between sections

On every panel, regardless of height, the rear support battens extend below the bottom slat by an amount matching the chosen gap:

• 7mm-gap panels: an extra 7mm.
• 20mm-gap panels: an extra 20mm.

These extensions maintain the correct spacing where the sections meet, creating a consistent slatted appearance throughout your finished fence.

Please see the last image in the product gallery for an illustrated guide to all the height combinations.

If you have any questions about how your panels will be supplied or installed, please contact us before ordering.