Black Larch Slatted Fence Panel – Single-Sided – 7mm Gaps

Black larch slatted fence panel

This handmade single-sided horizontal panel combines the natural character of larch with a deep black finish. The slats are spaced with approximately 7mm gaps, creating clean lines while allowing light and air to pass through. It suits modern garden boundaries, patios and screening projects, while the visible timber grain gives each panel an individual appearance.

Panel specification

• Standard width: 183cm (6ft)
• Available heights: 30, 60, 90, 120, 150, 180 and 210cm
• Construction: single-sided horizontal slats
• Material: larch
• Finish: black, with visible timber grain
• Bespoke sizes: available on request

Colour and timber variation

Product photographs and screen settings can only provide a guide to the finished colour. Timber is a natural material, so grain, texture and shade will vary, and individual battens may absorb the finish differently. Contact us before ordering if colour matching is especially important.

Care of the finish

Clean gently using a soft brush and mild soapy water where required. Avoid aggressive pressure washing. Inspect the surface periodically and refresh it with a compatible exterior timber finish when needed.

Planning the installation

Check the finished opening, post spacing and required clearances before ordering. Posts, foundations, fixings and the installation method must be suitable for the panel dimensions and conditions at the property. Seek advice from a competent installer if you are unsure.

Delivery and lead time

Our black larch slatted fence panels are handmade to order. Standard production is normally completed within 10–14 working days, although lead times can vary during busy periods. Please contact us before ordering if your project is time-sensitive or requires a bespoke size.

Stackable Venetian Panels — How Your Order Will Be Supplied

Effective for orders placed on or after 12 October 2026.

To make panels easier to handle and help us offer a more affordable delivery service using one driver, Venetian fence panels above 90cm high will be supplied in stackable sections.

This applies to all our larch, Scandinavian redwood, cedar and coloured Venetian fencing ranges with either 7mm or 20mm gaps.

The sections are installed one above the other to create your ordered panel height. Once correctly installed, the finished appearance is exactly the same as a single full-height panel.

Sections supplied per ordered panel

Each section retains the ordered panel width. For example, a 150cm-high × 1830mm-wide panel will arrive as one 90cm-high section and one 60cm-high section, both 1830mm wide.

Consistent gaps between sections

On every panel, regardless of height, the rear support battens extend below the bottom slat by an amount matching the chosen gap:

• 7mm-gap panels: an extra 7mm.
• 20mm-gap panels: an extra 20mm.

These extensions maintain the correct spacing where the sections meet, creating a consistent slatted appearance throughout your finished fence.

Please see the last image in the product gallery for an illustrated guide to all the height combinations.

If you have any questions about how your panels will be supplied or installed, please contact us before ordering.